Moving And Storage Instructions - Herth+Buss ELPARTS Reanimator Bedienungsanleitung

Operating Instruction
9.4. Ensure that all of the booster compo-
nents are in place and in good working
EN
condition.
9.5. All other servicing should be perfor-
med by qualified service personnel.
9.6. If the supply cord is damaged, it must
be replaced by the manufacturer, its ser-
vice agent or similarly qualified persons,
in order to avoid a hazard.

10. Moving and storage instructions

10.1. Store the booster in an upright positi-
on, inside, in a cool, dry place.
10.2. Always make sure the booster is fully
charged before storing. When not in use, it
is highly recommended to leave the boos-
ter on charge.
IMPORTANT
Do not use and/or store the booster in
or on any area or surface where dama-
ge could occur if the internal battery
should unexpectedly leak acid.
www.herthundbuss.com
95980806 | 95980807
26
Operating Instruction
11. Troubleshooting
Problem Possible cause
Clamps are not making
a good connection to
the battery.
The booster battery is
The booster won't
not charged.
jump start my car.
The vehicle's battery is
defective.
The fuse has blown.
The 12V device is not
turned on.
The booster battery
The booster won't
is not charged.
power my 12V
device.
The 12V device draws
more than 15A or has
a short circuit.
The battery in the
The battery is bad (will
booster won't hold
not accept a charge).
a charge.
AC outlet is dead.
The green POWER
LED does not light
when charger is
Poor electrical
properly connected.
connection.
Desulfation was
The red BAD
unsuccessful.
BATTERY LED is lit
and yellow/orange
CHARGING LED is
flashing rapidly.
27
95980806 | 95980807
Reason/Solution
Check for poor connection to battery and frame.
Make sure connection points are clean. Rock
clamps back and forth for a better connection.
Check the battery charge status by pressing the
button on the front of the booster.
See LED Indicators section of this manual.
Have the battery checked.
Replace the power fuse (See section 8).
Turn on the 12V device.
Check the battery charge status by pressing the
button on the front of the booster.
See LED Indicators section of this manual.
Disconnect the 12V device. The internal breaker will
automatically reset after a minute or two. Try the
12V device again. If it happens again, replace the
12V device.
Have the battery checked.
Check for open fuse or circuit breaker at the
supplying AC outlet.
Check power cord and extension cord for a loose
fitting plug.
The battery may be defective. Make sure there
are no loads on the battery. If there are, remove
them. If there are none, have the battery checked or
replaced.
The battery may be defective.
Have battery checked or replaced.
EN