Powering The Antenna Using An External Power Supply Unit (Fig. 2C); Radio Reception - Hama 2K121703 Bedienungsanleitung

5.3 Powering the antenna using an external power supply
unit (Fig. 2c)
Warning
• Only operate the product from a socket that has been approved
for the device. The socket must be installed close to the product
and must be easily accessible.
• Disconnect the product from the power supply using the On/
Off switch – if this is not available, unplug the power cord from
the socket.
• If using a multi-socket power strip, make sure that the total
power consumption of all connected devices does not exceed
the power strip's maximum throughput rating.
• If you will not be using the product for a prolonged period,
disconnect it from mains power.
• Connect the coaxial cable of the antenna to the antenna input on
the digital TV or set-top box.
• Connect the USB cable to the antenna and to a suitable USB power
supply unit (not included) and plug the latter into a socket.
• Switch the antenna on using the on/off switch (4). The LED (3)
lights up.
• Switch on the digital TV (and the set-top box, if present).
5.4 Standing the antenna (Pic 3a) / wall mounting (Pic 3b)
The antenna can be stood vertically or horizontally thanks to a base
that can be flexibly fixed in place; or it can be mounted to a wall.
Release the fastening screw (5) and secure the base with the screw in
accordance with how you would like to stand the antenna. For wall
mounting, please use suitable screws and wall anchors (not included
in the delivery package) to attach the bracket (base) to the wall.
Note – Wall mounting
• Before mounting, check that the wall you have chosen is
suitable for the weight to be mounted Also make sure that there
are no electric, water, gas or other lines running through the
wall at the mounting site.
• After the product has been mounted, check that it is sufficiently
secure. You should repeat this check at regular intervals.
• Do not mount the product above locations where persons might
linger.
5.5 TV reception
Note
Please note that the number and quality of stations received
may vary depending on the position of the antenna and local
conditions.

5.6 Radio reception:

• The antenna can also be used for DAB reception.
• As most audio devices have an F-plug connection, please use a
coax socket-F socket adapter (not included).
Note
Please note that the number and quality of stations received
may vary depending on the position of the antenna and local
conditions.
6. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do
not use aggressive cleaning agents.
Note
Disconnect the device from the power supply before cleaning it or
if it is not going to be used for a long period of time.
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty
for damage resulting from improper installation/mounting, improper
use of the product or from failure to observe the operating instruc-
tions and/or safety notes.
8. Service and Support
Please contact Hama Product Consulting if you have any questions
about this product.
Hotline: +49 9091 502-0 (German/English)
Further support information can be found here:
www.hama.com
9. Declaration of Conformity
Hereby, Hama GmbH & Co KG declares that the radio
equipment type [2K121703] is in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity
is available at the following internet address:
www.hama.com -> 2K121703 -> Downloads.
3