Device Front Panel - HBM K800 Bedienungsanleitung

Operation
6.3

Device front panel

Display
The K800 displays its current operating state by means of status LEDs.
Active detuning is indicated by the 5 yellow LEDs.
Only one status LED can be active at a time; if a number of LEDs are on, there
is a fault.
LED 1 (POWER) lights up green when the power supply is on.
LED 2 (READY) and a signal generator can be software‐driven in computer
1)
operation .
Setting
The five calibration steps can be set manually for all eight measuring channels
in parallel using the step switch.
In the REMOTE setting, digital control is possible (see Section 6.2).
Step switch
Status LEDs for the 5 calibration steps
LED 1
LED 2
1)
If the signal tone causes interference, switch to manual mode: step switch not at REMOTE
K800 17
A01098_05_X00_00 HBM: public