Adjus Ng The Backrest Incline; Adjus Ng The Tautness Of The Backrest Canvas - Decathlon BW500 Gebrauchsanweisung

It's recommended that you define the posi oning of the protec on height in rela on to the wheels before
con nuing with adjus ng the incline of the backrest, in order to eliminate any clashes and needing to redo any
adjustments.
Removing the drive wheels.
●
Unscrew and remove the "P", "Q", "V" and "Y" screws which a ach the protec on to the frame and
●
which set the adjustment of the backrest incline.
Determine whether you need to remove the incline adjustment. You need to remove it if the "T"
●
screw has also been passed through the protec on. In this case, also remove the "T" screw, taking
care to note the sequence of the washers for when you put it back together.
Select the preferred posi on by using the "P" and "Q" slots nearest to the relevant holes.
●
Reinsert all the "P", "Q", "V" and "Y" screws that were previously removed and securely ghten them.
●
If the suppor ng "T" screw has been removed, it must be reinserted first.
4.7

Adjus ng the backrest incline

Before adjus ng the backrest incline, you should make sure that the clothing protec on rim is posi oned at
the desired height. If necessary, first adjust the height of the rim, following the instruc ons provided in
paragraph 4.7 and then con nue as follows with adjus ng the incline of the backrest. Opera ons should
always be carried out symmetrically on the right and le sides, in order to be able to make the required
rota ons. It is recommended that, when the screws are removed, you take note of the sequence of the
washers and thicknesses used, so that you can put them back in the right order.
Unscrew, without removing, the "P" and "Q" screws to release any locked rota ons and movements of
●
the clothing protec on rim.
Unscrew, without removing, the "T" screws to release the rota on of the backrest.
●
Unscrew and remove the "V" screw which a aches the incline adjustment onto the seat frame.
●
Select the new incline of the backrest.
●
Find the hole from those iden fied by "V1, V2, V3, V4" which match up with one of the holes on the
●
frame, iden fied by "U1, U2, U3, U4".
Once you've found the corresponding hole, insert the "V" screw and properly secure it to set the
●
posi on of the adjustment.
Con nue by ghtening the "F", "P" and "Q" screws which were previously unscrewed.
●
4.8

Adjus ng the tautness of the backrest canvas

Li the rear sec on of the canvas.
●
Loosen the straps.
●
With the athlete in playing posi on, pull taut the straps as much as necessary, star ng with the top
●
strap.
Fold the backrest canvas back again.
●
Try some game movements and repeat the opera on if the posi on isn't quite right.
●
12