Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MIC Menu (3 Band Equalizer)
Bass Gain
Bass + -
Middle Gain
Middle + -
Treble Gain
Treble + -
Setting 0,0 dBu neutral
0.1....12dBu:
increases Bass/Mid/Treb
-0.1--- -12dBu
reduces Bass/Mid/Treb
Extreme settings of any EQ band will not
be necessary with good quality micropho-
nes and loudspeakers.
Having completed settings, quit menu via
uII
EXIT
back to the home screen.
Auto Mute, Noisegate ...
Find further settings for input channels
MIC1 and MIC2 in the system menu (SYS)
RM5D front elements
MUSIC VOL
Sets the audible music level going to the
XLR outputs on the rear panel.
MIC VOL
sets the audible music level going to the
XLR outputs on the rear panel for MIC1
and MIC2.
If MIC1 and MIC2 have been set to diffe-
rent levels in Menu MIC Gain, this audible
difference will remain.
EFF VOL
Sets the Level of effect (Echo / Reverb)
added to MIC1 and MIC2. Should EFF (in
the admin menu) have been enabled only
for MIC 1 gesetzt, this control will have no
effect on MIC 2.
Signal
Starts the signal stored on a Micro SD
Card (MP3 file) by pushing the front side
button or a foot pedal connected to the
SIGNAL FS socket on the rear panel. The
Start Signal Level is set in the SYS Menu
(Signal VOL).
Signal Sources AUX
Connect analog signal sources such as CD/
Multi Media Players or other units with
AUX (RCA/Cinch) cables.
Connect to AUX Input 1 and 2.
Select in Menu SYS Input Aux1 / Aux2
or by IR remote control.
Auto Mute MIC1, MIC2 on / off
Auto Mute ON, will give the selected MIC
channel priority over any music program.
Music level will be reduced, while the
microphone is in use.
Noise Gate Threshold MIC1, MIC2
Sets the level to fully open the selected
MIC channel when speaking into the
microphone from a short (3cm) distance.
Noisegate CH
Mic1
enables / sets Noisegate to MIC1
Mic2
enables / sets Noisegate to MIC2
Noisegate Thr (Threshold)
Sets the sound pressure Level as to when
the microphone should open.
IR Remote Control
Mute
Interrupts the current
music
programm
EFF-
reduces the volume of
the echo/reverb effect
MIC-
reduces the volume
of the
microphone(s)
USB / BLT
remote control
next track, previous track...
BLT source must qualify
Select
Presets
USER 1...4
technische Änderungen vorbehalten - specifications may change without notice
Range: -5dBu...-90dBu.
Low value: Noisegate will only open at a
very high voice level.
High value (-70..-90dBu): noisegate will
open at a lower voice level.
Dynamic microphones (like BELL M290V)
should always be used from a very short
distance (likely 3cm), in order to avoid
interference from ambient noise.
Noisegate State
Noisegate function on / off
(separately for each MIC channel)
For further functions and settings, refer to
the following spec sheets.
EFF+
increases the volume
of the echo/reverb effect
MUSIC+
increases the volume
of the
music program
MIC+
increases the volume
of the
microphone(s)
MUSIC-
reduces the volume
of the
music program
®
Werbung
