Service And Support - Sea-Bird Scientific SBE 19plus V2 SeaCAT Bedienungsanleitung

Section 6 General information
This product can expose the user to chemicals with silica, crystalline (airborne particles of respirable size), which
is known to the State of California to cause cancer and birth defects or other reproductive harm. For more
information, go to www.P65Warnings.ca.gov.
6.1 Warranty
Refer to the manufacturer's website for warranty information (seabird.com/warranty).

6.2 Service and support

The manufacturer recommends that sensors be sent back to the manufacturer annually to be
cleaned, calibrated, and for standard maintenance.
Refer to the website for FAQs and technical notes, or contact the manufacturer for support at
support@seabird.com. Do the steps below to send a sensor back to the manufacturer.
1. Complete the online Return Merchandise Authorization (RMA) form or contact the manufacturer.
Note: The manufacturer is not responsible for damage to the sensor during return shipment.
2. Remove all batteries from the sensor, if so equipped.
3. Remove all anti-fouling treatments and devices.
Note: The manufacturer will not accept sensors that have been treated with anti-fouling compounds for service
or repair. This includes AF 24173 devices, tri-butyl tin, marine anti-fouling paint, ablative coatings, etc.
4. Use the sensor's original ruggedized shipping case to send the sensor back to the manufacturer.
5. Write the RMA number on the outside of the shipping case and on the packing list.
6. Use 3rd-day air to ship the sensor back to the manufacturer. Do not use ground shipping.
7. The manufacturer will supply all replacement parts and labor and pay to send the sensor back to
the user via 3rd-day air shipping.
6.3 AF24173 anti-foulant device
AF24173 Anti-Foulant Devices supplied for user replacement are supplied in polyethylene bags
displaying the following label:
AF24173 ANTI-FOULANT DEVICE
FOR USE ONLY WITH SEA-BIRD ELECTRONICS' CONDUCTIVITY SENSORS TO CONTROL
THE GROWTH OF AQUATIC ORGANISMS WITHIN ELECTRONIC CONDUCTIVITY SENSORS.
ACTIVE INGREDIENT: Bis(tributyltin) oxide . . . . . 52.1%
OTHER INGREDIENTS: . . . . . . . . . . . . . . . . . . . . 47.9%
TOTAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100.0%
DANGER
See Precautionary Statements for additional information.
12 English
W A R N I N G