Sea-Bird Scientific SBE 19plus V2 SeaCAT Bedienungsanleitung Seite 10

8. Push the DISCHARGE button on the charger.
This starts the discharge cycle, so that any voltage in the batteries is discharged. This increases
the life of the batteries. Discharge takes approximately 75 minutes. When complete, the LED
shows EMPTY.
9. Push the CHARGE button.
The LED shows FAST CHARGE (or WARM-UP CHARGE, or REFILL CHARGE, or TOP-OFF.)
The FAST CHARGE cycle takes approximately 2 hours. The REFILL CHARGE takes
approximately 15 hours. When the batteries are charged, the LED shows BATTERY FULL.
10. Turn off power to the charger.
11. Disconnect the charger cable from the battery pack and the power supply.
12. Install the battery pack into the housing again:
a. The battery pack fits tightly in the housing. Align it carefully and slowly insert it straight into the
housing. Be careful not to tear the shrink wrap on the battery pack.
b. Install the three cap screws into the top plate.
c. Push firmly on the protective plastic plate to make sure that the spring is fully in contact with
the batteries.
d. Make sure that the screws are fully tightened or the battery power will be intermittent.
13. Carefully put the end flange onto the housing and screw the end flange into place. use a wrench
to make sure the cap is tightly installed.
14. Verify that the switch plunger is pulled out so that the Searam is in a low power mode.
Section 5 Antifouling devices
AF24173 anti-fouling devices contain bis(tributyltin) oxide. Wear rubber or latex gloves and eye protection to
replace these devices on the sensor if it is so equipped. Wash hands with soap and water when finished.
Read the precautions on the product label.
It is a violation of US federal law to use this product in a manner that is inconsistent with its label.
5.1 Verify anti-fouling devices
New sensors have two anti-fouling devices and a yellow protective label installed by the
manufacturer.
10 English
C A U T I O N