Herunterladen Inhalt Inhalt Diese Seite drucken

Maintenance; Maintenance Schedule - Husqvarna LC 356VP Bedienungsanweisung

Vorschau ausblenden Andere Handbücher für LC 356VP:
Inhaltsverzeichnis

Werbung

Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.

Maintenance

Do a general inspection
Examine the oil level
Clean the product
Examine the cutting equipment
Examine the cutting cover *
Examine the engine brake handle *
Examine the blade brake control *
Examine the muffler *
Examine the spark plug
Replace the oil (the first time after 5 h of use, then after each 50 h of
use)
Clean or replace the air filter
Examine the fuel system
To do a general inspection
Make sure that all nuts and screws on the product
are tightened correctly.
To clean the product externally
Use a brush to remove leaves, grass and dirt.
Make sure that the air intake on the top of the engine
is not blocked.
Do not use a high pressure washer to clean the
product.
If you use water to clean the product, do not flush
water directly on the engine.
To clean the inner surface of the cutting
cover
1. Empty the fuel tank.
2. Put the product on its side with the muffler down.
1583 - 007 - 07.10.2022
Maintenance
Before you do

Maintenance schedule

CAUTION:
is up and not against the ground when you
tilt the product. Risk of engine damage.
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * refer to instructions in
Safety devices on the product on page 9 .
Daily
X
X
X
X
X
X
X
CAUTION:
with the air filter down, the engine can
become damaged.
3. Hose down the inner surface of the cutting cover
with water.
To examine the cutting equipment
WARNING:
remove the ignition cable from the spark
plug.
WARNING:
when you do maintenance on the cutting
equipment. The blade is very sharp and cuts
can easily occur.
Make sure that the air filter
Weekly
Monthly
X
X
X
X
X
If the product is put
To prevent accidental start
Use protective gloves
13

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis