Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cleaning and Disposal of Devices
To clean the Wireless Radiator Controller / Timer,
use only a dry or lightly damp cloth. Avoid chemical
solvents, as these may damage the device.
Adapters
Heimeier, Junkers Landys+Gyr,
MNG, Honeywell Braukmann
M30 x 1.5 thread
Danfoss RAV (included pin
must be inserted into valve
tappet)
Danfoss RA
Danfoss RAVL
Please completely remove all connecting pieces on
the plastic adapters before using any of the included
adapters.
Completely remove the connecting rods marked in
grey before installing the adapters.
16
No adapter
required
+ included pin,
only for RAV
Help
Problem
Cause
Batteries nearly
dead.
Radiator
Water tempera-
will not
ture in boiler
heat up.
okay? Valve will
not open after
heat was off for
the summer
– limescale
build-up?
Radiator
Valve is not clo-
will not
sing completely.
cool down
The point where
your valve seal
closes may have
shifted.
Compres-
Because the
sion piece
device has an
fell out.
endless screw,
(This can
the compression
also cause
piece on the
an E1
bottom can
error.)
fall out if the
controller is not
mounted on the
valve.
Pressing any button deletes the error shown
-
on the display and starts the adaptation
process again.
Adaptation not
possible. The
Wireless Radiator
Controller / Timer
not mounted on
radiator.
Valve stroke too
short or battery
power too weak.
Valve will not
move.
Solution
Replace the batteries.
Correct temperature of wa-
ter in boiler. Disassemble
the Radiator Controller.
Move valve tappet back
and forth multiple times by
hand or with a tool.
Carry out adaptation again
(see "Adaptation"). Move
valve tappet multiple times
by hand – adaptation may
not be possible because
your valve may have
limescale build-up or the
seal may no longer be
functioning.
Insert the compression
piece. Start the adaptation
process using the
MENU
item or by removing and
reinserting the batteries.
The endless screw rotates
and tightens the compres-
sion piece again. Mount
device on radiator and
perform adaptation again.
Device correctly mounted
on radiator? Mount the
Wireless Radiator Control-
ler / Timer.
Open and close valve tap-
pet multiple times by hand
or insert new batteries.
Can the valve tappet move
freely?
Werbung
Inhaltsverzeichnis
