Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Offset
If the temperature in an area of the room differs from
the set temperature, you can perform a temperature
offset. Press
. Select the
MENU
using the setting wheel. Confirm with
The degree setting
Now set the desired temperature offset (from -5 to
+5 °C) using the setting wheel. Press
temperature shown on the display does not change.
Window function
If you open a window, causing the temperature to
drop rapidly, the Wireless Radiator Controller / Timer
automatically closes the heating valve to save energy.
appears on the display. The Wireless Radiator
Controller / Timer resumes normal operation
afterwards. To set up this function, select
Confirm with
. First select the sensitivity using
OK
the setting wheel (
moderate sensitivity (default setting)
sensitivity). Confirm with
Now select the time (10 min (factory setting) - 60
min) for which the valve should remain closed.
Confirm with
.
OK
Holiday function
You can specify a set temperature for the time
you are away. The schedule you have set resumes
after the holiday period. Press
menu item using the setting wheel. Confirm
with
. (The case symbol
OK
display.) Use the setting wheel to set the end time for
the holiday function = date for regular heating times
to resume). Confirm with
and confirm with
OK
Now set the temperature and confirm with
appears on the display. You can deactivate the
function with
.
MENU
menu item
.
OK
flashes on the display.
. The
OK
= high sensitivity,
> = low
.
OK
. Select the
MENU
appears on the
. Then enter the time
OK
.
flashes on the display.
OK
Child protection
You can lock the Wireless Radiator Controller / Timer
to prevent unauthorised operation. To do so, press
and hold
2 sec. until the symbol flashes on the display.
Holding this combination again causes the symbol to
disappear and removes the lock.
Pause heating/close valve
Press
MENU
setting wheel. Confirm with
wheel to set the temperature on the display to
. The valve is now closed and operates without
a schedule. The once-weekly limescale prevention
function remains active. After the pause in heating,
switch to AUTO mode in the menu to resume the
.
schedule you have set.
All reset
Press
> =
MENU
setting wheel. Confirm with
confirm with
Controller / Timer is now in back to the state in which
it was delivered. Proceed as though you were starting
up the device for the first time.
The frost protection and limescale prevention
functions are automatically active:
Frost protection function
If the temperature falls below 6 °C, the Wireless
Radiator Controller / Timer opens the valve until the
temperature climbs above 8 °C. This prevents the
radiator from freezing.
Limescale prevention function
To prevent limescale from forming in the radiator
valves, the Wireless Radiator Controller / Timer
.
performs a limescale prevention run once per week
(Friday morning).
+
simultaneously for approx.
OK
. Select the
menu item using the
OK
. Select the
menu item using the
OK
.The Wireless Radiator
OK
. Use the setting
.
flashes;
15
Werbung
Inhaltsverzeichnis
