Xenteq PTS Serie Gebrauchsanweisung Seite 12

Important
- The X-com function (RJ 45 connection) of the PTS switch box can
only be used for the PurePower(Plus) inverters!
- The X-com function only works when the mains is connected to the
'Mains input' and the inverter is connected to the 'Inverter input'
- The X-com function (RJ45 connection) can NOT be used in combi-
nation with the also available potential free contact. It is therefore
not possible to connect and use both functions. Simultaneous use
can result in defects.
- Because the connecting cable is routed into the housing, this will
affect the IP value. The specified IP classification in the specifications
will no longer be achieved.
Potential free contact
There is also a potential-free contact within the PTS 230-25. This can
be used for all kinds of purposes, such as switching on a generator if
the 230VAC is lost, switching on/off an inverter or generating a
(warning) signal. The maximum load is 8Amp.
Important
- The potential free contact can NOT be used in combination with the
X-com function (RJ45 connection). It is therefore not possible to
connect and use the two functions. Simultaneous use can result in
defects.
- Because the connecting cable is routed into the housing, this will
affect the IP value. The specified IP classification in the specifications
will no longer be achieved.
You will find a grommet on the left side of the PTS
housing. Cut away the part that is needed to feed the
used cable through. Connect the cable to the relevant
blue connector using pressure connectors.
EN
12