Herunterladen Inhalt Inhalt Diese Seite drucken

Xenteq PTS Serie Gebrauchsanweisung Seite 10

Vorschau ausblenden Andere Handbücher für PTS Serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

1.
Route the power supply cable through the right grommet and connect
it to the 3 screw connectors on the circuit board (MAINS INPUT).
See diagram opposite.
2.
Route the power cable for the output/users through the middle
grommet and connect it to the corresponding 3 screw connectors
on the circuit board (OUTPUT). See diagram below.
3.
Route the power cable for the inverter/generator through the left
grommet and connect it to the 3 screw connectors on the circuit
board (INVERTER INPUT). Connect the other side of the power cable
to the inverter/generator.
4.
Sufficiently tighten all grommets on the PTS 230-25, however fixed is
fixed.
5.
Optional with the PTS 230-25: if required, connect one of the
remaining contacts inside. See paragraphs 'Switching
PurePower(Plus) inverter on/off' and 'Potential free contact'.
6.
Close the housing by screwing the four screws back into the front
cover.
Press the suppled corner pieces onto the four corners of the PTS
230-25 housing.
INVERTER
INPUT
L
N
PE
Inverter/
generator
OUTPUT
L
N
PE
l
OUTPUT
MAINS INPUT
PE
N
L
l
MAINS
EN
L=
phase (brown)
N= neutral (blue)
PE= ground (green-
yellow)
10

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Pts 230-10Pts 230-25

Inhaltsverzeichnis