tau LUXE-S Bedienungs- Und Wartungsanleitung Seite 19

6.6 Bar fixing
Balancing is fundamental for the correct function of the barrier.
This operation is only performed after the bar has been fitted in its final position with all possible accessories.
All operations are performed with the power supply switched off and the barrier released (see chapter "manual release"):
1. Close the end with the supplied cap (E); insert the bar (A) into the bar holder (B) and secure it with the 2/4 bolts (C) and nuts (D);
Important: the boom must be completely inserted into the boom holder.
D
A
B
A
B
A
C
2_ LUXE-M + AE: when the omega bracket is fixed, and after
removing the protective cap, pass the LED cable through
the hole on the cabinet (to take the cable to the control
unit, refer to figure) then fit the cover and secure it with
the screws supplied;
A) Position the led connection cable "A".
B) LED stripes
C) 90° articulated cable gland
D) Tear proof cable seal
3_ place the bar in a vertical position and block the gearmotor
(see the "Manual release" chapter).
19