Comelit Hub 20003150 Technisches Handbuch Seite 7

Reset procedure
Restart with default network parameters
The restart with default parameters function is used to restart the product with the default network parameters
while keeping the remaining settings unaltered.
√ DIP-switches in default position (OFF)
1. Switch off the power supply to the device
2. Set DIP1 to ON
3. Restore the device power supply
4. Wait for approximately 20-40 sec., until the LEDs flash slowly and alternately
(1 sec. red / 1 sec. green)
5. et all DIP-switches back to OFF
» The green LED will flash for 5 seconds
» The device will start up with the default network settings applied
6. The next time the device is restarted, the saved parameters will be restored
Restore factory settings
This procedure is used to restore the factory settings of all parameters (ViP address, network parameters and
home automation project).
√ DIP-switches in default positions (OFF):
1. Switch off the power supply to the device
2. Set all the DIP-switches to ON
3. Restore the device power supply
4. Wait for approximately 20-40 sec., until the LEDs start flashing rapidly and alternately
(0.1 sec. red / 0.1 sec. green)
5. Set all DIP-switches back to OFF
» The red LED will flash for 5 seconds
» The device will restore all parameters to the factory settings and restart in the normal
way
Reset communication password
√ DIP-switches in default positions (OFF):
1. Switch off the power supply to the device
2. Set DIP2 to ON
3. Restore the device power supply
4. Wait for approximately 20-40 sec., until the LEDs start flashing rapidly and alternately
(1 sec. red / 1 sec. green)
5. Set all DIP-switches back to OFF
» The LEDs will flash alternately (0.5 sec. red / 0.5 sec. green); the device will restart with
the password reset
1 2
OFF
1 2
OFF
1 2
OFF
1 2
OFF
1 2
OFF
1 2
OFF
1 2
OFF
1 2
OFF
1 2
OFF
7