Eder Trough Cutter Eth-C - eder ESG-C 400200 Bedienungsanleitung

Fig. 15: Replacing knives on the carving cutter
> Loosen the knife screw (2 - Fig. 15) slightly.
> Place the knife gauge (4 - Fig. 15) on the milling head (1 - Fig. 15)
> Fix the knife in this position by slightly tightening the knife screw.
> Retighten the knife screw. Tightening torque: 35 Nm

EDER Trough Cutter ETH-C

Sharp knives are required for optimal work with the EDER Trough
Cutter ETH-C.
All 4 knives are exchanged and adjusted in the same way. Proceed as
follows for each knife:
Fig. 16: Replacing knives
> Loosen the knife screws (1 - Fig. 16) on the milling head (3 - Fig.
75 Attachments with chain drive
and slide the knife (3 - Fig. 15) against the gauge until it touches
the notched area.
Blunt circular knives can be turned by 180° around the knife
screw and used again. The circular knives can be
i
resharpened. The rounding radius of the circular knives must
be maintained for good work efficiency.
1
16) with a 6 mm Allen key.
2
3
409001_03 | 10.2022