Mounting The Attachment - eder ESG-C 400200 Bedienungsanleitung

Mounting the attachment

> Place the guide bar (1 - Fig.1) between the screws (2 - Fig.1) in the
> Note that the bar is not symmetrical. The oil holes are in different
> Check that the oil hole of the guide bar is on the oil groove of the
61 Attachments with chain drive
Danger from changes to the device!
This may result in injury.
> Only carry out assembly work described in this manual.
> Do not adjust the support, the chain, the knives or the milling
head while the engine is running. The chain must be correctly
tensioned.
> Only use original spare parts. These can be ordered directly
from Eder Maschinenbau GmbH or from your dealer (see back
page for address)
Converting and using the chainsaw with the Eder attachments
voids the chainsaw's warranty. Eder Maschinenbau GmbH
accepts no liability for damage to the chainsaw!
> Use a new sprocket on your chainsaw before using the
attachment. Retracted sprockets/chainrings can lead to
damage or higher wear on the drive chain.
> The sprocket/chainring used on the drive motor must have a
maximum of 7 teeth.
> When fitting, make sure you have the correct designation for
your sprocket/chainring. 3/8 LP, 3/8 Micro, 3/8 Hobby, 3/8
Picco etc. are not compatible with 3/8".
same way as a normal chainsaw bar.
positions on the two sides of the bar. Choose the correct side of
the guide bar depending on the chainsaw used.
chainsaw - if not, turn the guide bar over. (To check the position,
clean the saw around the oil groove and apply some oil in the oil
groove. Then place the guide bar against the chainsaw in its
WARNING
ATTENTION
409001_03 | 10.2022