Commissioning And Operation - eder ESG-C 400200 Bedienungsanleitung

> Put the side plate back on the device, slightly fasten it and tension
> Tighten the screws of the side plate firmly.

Commissioning and operation

Before starting the motorised handheld device, make sure you have
safe working conditions. Check that
> the attachment has been correctly mounted,
> the chain is sufficiently tensioned and not damaged,
> the chain brake is functional,
> all knives and tools are correctly mounted and firmly seated
> the handles are clean and dry,
65 Attachments with chain drive
Only use chains and drive sprockets matching the chainsaw and
having the same pitch.
the chain. A new chain needs to be retensioned more often. Check
the chain tension more often.
Chain tension
> Check the chain regularly for correct chain tension. To do this,
always switch off the engine!
> The chain is correctly tensioned if you can pull it slightly out of
the guide bar by hand with the chain brake released. The chain
must not be lifted more than 4 mm from the guide bar.
Damage to knives and tools!
Nails, adhering sand and other foreign bodies can damage the
knives and tools of the attachment.
> Check the logs to be worked before each use. If necessary,
remove nails, sand and other foreign objects before milling.
(tightening torque 35 Nm)
ATTENTION
ATTENTION
ATTENTION
409001_03 | 10.2022