VONROC JS501DC Bersetzung Der Originalbetriebsanleitung Seite 9

Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with a
standardized test given in EN 62841; it may be used
to compare one tool with another and as a prelimi-
nary assessment of exposure to vibration when using
the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-4.
1. Lock-off button
2. On/off switch
3. Handle
4. Battery
5. Battery unlock button
6. Pendulum action switch
7. Scale for bevel angle
8. Baseplate cover
9. Baseplate
10. Guide roller
11. Laser switch
12. Guard
13. Clamping lever
14. Wing bolts for parallel guide
15. Hex key
16. Chuck
17. Saw blade
18. Bolt for baseplate
19. Parallel guide
20. Laser
21. Cutting mark
22. Laser adjustment screw
23. Battery LED indicators button
24. Battery LED indicators
25. Charger
26. Charger LED indicators
3. ASSEMBLY
Before any work on the power tool, remove
the battery.
WWW.VONROC.COM
The battery must be charged before first use.
Inserting the battery into the machine (Fig. A, G)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (4) into the base of the machi-
ne as shown in Fig. G.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. A, G)
1. Push the battery unlock button (5)
2. Pull the battery out of the machine like shown
in Fig. G.
Checking the battery charging status (Fig. I)
• To check the battery charge status, push the
button (23) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more char-
ge the battery has left.
• When the lights are not burning it means the bat-
tery is empty and must be charged immediately.
Charging the battery with the charger (Fig. I)
1. Take the battery (4) from the machine.
2. Turn the battery (4) to upside down position and
slide it onto the charger (25) as shown in Fig. I.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet and
wait for a while. The LED indicators on the charger
(26) will lighten up and show the charger status.
The charger has 2 LED indicators (26) which indi­
cate the status of the charging process:
Red LED Status Green LED status
Off Off
Off On
On Off
EN
Charger status
No power
Standby mode:
- No battery is
inserted or,
- Battery inserted
but charging has
finished
Battery charging in
progress
9