Adjustment Of The Distance Between Spindle And Pivot Point; Adjustment Of The Tonearm - clearaudio electronic VERIFY Bedienungsanleitung

User manual / Bedienungsanleitung

4. Adjustment of the distance between spindle and pivot point

We recommend to use the Clearaudio alignment gauge (Art. No. AC005/IEC, also available from
www.analogshop.de) for the exact setting of the tonearm pivot point.
Make sure that the distance between spindle and the pivot point of the tonearm is exactly 222mm.
You can adjust the distance by rotating the tonearm base.
Please tighten the tonearm base and check the measurement again after adjustment.
Pic. 7: Distance from pivot to stylus

5. Adjustment of the tonearm

The following settings require to mount the cartridge on the headshell.
Always follow the cartridge manufacturer's instructions.
Leave the stylus protector on your cartridge to avoid any damages!
Pic. 8: Cartridge mounting
Page / Seite 10
Now you can connect the respective signal cable with the matching color
pins of the cartridge.
Please note the following colour coding:
Red:
right channel / R+
Green:
right channel / R-
White:
left channel / L+
Blue: left channel / L-
Connect the pins of your cartridge to the jacks of the headshell or tonearm
cable, taking care not to use too much force.
Use suitable precision pliers or tweezers for assistance if necessary.
© clearaudio electronic GmbH, 2022-11