Alignment And Adjustment Of The Cartridge - clearaudio electronic VERIFY Bedienungsanleitung

User manual / Bedienungsanleitung
Pic. 10: Alignment of the tonearm
Pic. 11: The tonearm tube must be absolutely parallel
Pic. 12: Stylus tip on reference point
Page / Seite 12
5.2 Alignment and adjustment of the
cartridge
Use the adjustment template, included in the
scope of the delivery for the final tonearm and
cartridge adjustment.
Place it directly on the turntable (without
record) and align it with the arrow pointing
toward the tonearm pivot point (Pic. 10).
Take the tonearm out of the rest position and
align it in the area of the cross lines.
Lower the tonearm and check the alignment.
The cartridge body must be aligned in the
template grid and the needle tip should be
located in the cross lines.
Also, the side and front edges of the housing
have to be parallel to the grid lines.
To correct the adjustment, loosen the screws
of the cartridge to move the cartridge in the
headshell.
Re-check the setting again after you have
tightened the screws.
© clearaudio electronic GmbH, 2022-11