Mounting The Tonearm Base; Mounting The Tonearm Base On The Clearaudio Performance Dc Or Ovation Turntable - clearaudio electronic VERIFY Bedienungsanleitung

User manual / Bedienungsanleitung

2. Mounting the tonearm base

2.1 Mounting the tonearm base on the Clearaudio Performance DC or Ovation turntable

Please check if the correct tonearm base is mounted on your turntable (Pic. 2).
If the wrong tonearm base is mounted place the turntable on the edge of a table or similar surface
to gain access to the tonearm base from below.
Remove the tonearm base by loosening the six M4 x 35mm screws with a hex wrench on the bottom
side of the clamping ring.
Exchange the tonearm base and loosely tighten the screws to keep the tonearm base rotatable.
Please ensure the perfect location of the base.
Pic. 2: Tonearm base for concept & Performance DC & Ovation
(Art. No. AC031-4)
Made in Germany Page / Seite 7