Alarm Setting - Seecode 20300 Bedienungsanleitung

Press and hold for 3 seconds to switch from sensor 1 to sensor 2.
Press and hold for 3 seconds, „TEMP SET" starts flashing. Press ‚' " and „ " to change the set temperature for
the selected probe and press to confirm. After 30 seconds of no activity, the unit will automatically return to display
mode.
4.8

Alarm setting

2) In display mode, press to turn the alarm function on or off. The alarm symbol appears, the order is Sensor 1 ON -
Sensor 2 ON - Sensor 1 + Sensor 2 ON - Sensor 1 + Sensor 2 OFF.
When the alarm function is switched on, the alarm is triggered as soon as the set temperature is reached.
The alarm symbol flashes, the orange light flashes, probe 1 beeps for 1 second and probe 2 beeps twice. Once both
probes are on in the alarm function, it beeps three times.
To turn off the alarm, press any button to stop the beep. This will cause the orange light to go off and the blue light to
come on for 10 seconds. After 5 minutes, a beep sounds again if the temperature is above the desired temperature. If
the temperature is always below the set temperature, the alarm will not sound again.
5. operating the transmitter
Note: Do not place the monitor in direct sunlight or allow it to come into direct contact with moisture or hot surfaces.