Intended Use - Makita DMC300 Betriebsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
W h e e l o u t e r d i a m e t e r
W h e e l i n n e r ( a r b o r ) d i a m e t e r
Ma . wheel thickness
Ma . cutting capacities
Rated speed (n) / No load speed (n
Overall length
Rated voltage
Net weight
1. With battery cartridge (BL18
Due to our continuing program of research and development, the speci cations herein are subject to change
without notice.
Speci cations and battery cartridge may di er from country to country.
The weight may di er depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 1/
Applicable battery cartridge and charger
Battery cartridge
Charger
Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or re.

Intended use

The tool is intended for cutting a sheet, tting, pipe, tile
or wall in metal, plastic, ceramic, plaster and similar
composite materials without use of water.
Noise
The typical A-weighted noise level determined accord-
ing to EN 5- - :
Sound pressure level (L
Sound power level (L ) :
WA
Uncertainty (K) : dB (A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
a n o t h e r .
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
e posure.
With dust collect cover
Without dust collect cover
)
0
B) / Without dust collection cover
) : 88 dB (A)
pA
dB (A)
1 . mm / .5 mm ( /8 ) (country speci c)
1 , are shown in the table.
BL1815N / BL18 B / BL18
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
DC 18S H / DC 18W C
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can di er from the declared
value(s) depending on the w ays in w hich the
tool is used especially w hat kind of w orkpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times w hen the tool is s w itched
o and when it is running idle in addition to the
trigger time).
Vibration
The vibration total value (tri-a ial vector sum) deter-
mined according to EN
Work mode: concrete cutting (thickness 5 mm)
Vibration emission (a
Uncertainty (K) : 1.5 m/s
8 ENGLISH
DMC300
7 6 m m
1.0 m m
13.5 m m
16.0 m m
-1
20, 000 m i n
27 1 m m * 1
D.C . 18 V
1. - 1. kg
B / BL18 B / BL185 B / BL18
5- - :
2
) : . m/s
h
2
B