Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
A-6
Installing an internal Scorpion 40
Before you begin
!
•
•
•
•
Installation Overview
Internal drive installation involves three main steps:
1. Configuring the drive
2. Mounting the drive
3. Connecting the power and interface cables
Note: Internal Scorpion 40 drives come in different
Configuring an internal Scorpion 40
Before you install the tape drive in your computer, you may
need to configure the drive's SCSI ID or other drive features.
Caution. Observe the following precautions to avoid
electrostatic damage to the internal drive during
installation.
Do not remove the drive from the antistatic bag until you
are ready to install it.
Before you remove the drive from the antistatic bag, touch
a grounded metal surface to discharge any static
electricity buildup from your body.
Hold the drive only by its edges and avoid direct contact
with any electronic components.
If you need to put the drive down, lay it on top of the
antistatic bag or place it inside the bag.
configurations for mounting in 3.5-inch and 5.25-inch
drive bays. Drives configured for 5.25-inch bays are
identical to those used for 3.5-inch bays, but come with
mounting brackets and a wider face plate. Installation
procedures are the same for both drive configurations.
Scorpion 40 Installation Manual: English
Werbung
Inhaltsverzeichnis
