Mounting The Coupler Onto A Bicycle - Velmia THC2 Gebrauchsanleitung

INSTRUCTIONS FOR USE [AE]

5. Mounting the coupler onto a bicycle

DANGER
Make sure that your bicycle is suitable for towing a bicycle trailer,
see "Performance limits" under point 4. Since it may in some cases
be necessary to change the rear wheel axle, it is best to consult
your specialist dealer or the bicycle manufacturer in order to do
this.
CAUTION
Secure the bicycle to prevent it from toppling over, and make sure
that the rear wheel cannot drop out of the axle mount after the
screw connection has been undone. Use for example an assem-
bly stand, or turn the bicycle upside down so that you can place it
on its saddle and handlebars.
1. Prepare the bicycle for mounting the coupler by undoing the
screw connection of the rear wheel axle:
- Quick-release axle: Open the bracket of the quick-release
axle and unscrew the cap nut on the other side of the rear
wheel axle.
- Full axle: Unscrew the nut on the left side of the rear wheel
axle.
2. Mount the coupler on the rear wheel axle:
- Place the large hole of the coupler onto the left side of the
rear wheel axle so that the coupler is facing outwards.
- Screw on the dedicated nut and tighten it slightly.
13