Siemens ET 200eco PN Produktinformation

SIMATIC
Distributed I/O
Configuring ET 200eco PN Fail-Safe Modules with a GSDML
File
Product Information
Security information
Siemens provides products and solutions with industrial security functions that support the secure operation of plants,
systems, machines and networks.
In order to protect plants, systems, machines and networks against cyber threats, it is necessary to implement – and
continuously maintain – a holistic, state-of-the-art industrial security concept. Siemens' products and solutions constitute one
element of such a concept.
Customers are responsible for preventing unauthorized access to their plants, systems, machines and networks. Such
systems, machines and components should only be connected to an enterprise network or the internet if and to the extent
such a connection is necessary and only when appropriate security measures (e.g. firewalls and/or network segmentation)
are in place.
For additional information on industrial security measures that may be implemented, please visit
(https://www.siemens.com/industrialsecurity).
Siemens' products and solutions undergo continuous development to make them more secure. Siemens strongly
recommends that product updates are applied as soon as they are available and that the latest product versions are used. Use
of product versions that are no longer supported, and failure to apply the latest updates may increase customers' exposure to
cyber threats.
To stay informed about product updates, subscribe to the Siemens Industrial Security RSS Feed visit
(https://www.siemens.com/industrialsecurity).
Introduction
Note the following dependencies for PROFINET IO during configuration of ET 200eco PN fail-safe modules with a GSDML file.
Note
When using ET 200eco PN fail-safe modules with a GSDML file on non-Siemens PROFIsafe masters, note that the warnings,
information, and references contained in the F-module device manuals are still valid.
Please also observe the warnings, information, and references of the non-Siemens master.
Requirement
S7-FCT is required to calculate the F_iPar_CRC and perform PROFIsafe addressing for the F-I/O according to PROFIsafe address
type 2.
You can find instructions and additional information for the SIMATIC S7-FCT V3.0 - Fail-safe Configuration Tool on the
Internet (https://support.industry.siemens.com/cs/us/en/view/109763833).
You can find S7-FCT on the Internet (https://support.industry.siemens.com/cs/ww/en/view/109762827).
Note
If identification of the F-module does not succeed during the assignment of the PROFIsafe address (for example, the F-
module's channel LEDs flash continuously), you can take the following corrective measures:
• Repeat the assignment of the PROFIsafe address after approximately 5 minutes.
• Power cycle the F-module and then repeat the assignment of the PROFIsafe address.
• Increase the PROFINET update time of F-host and IM for the duration of the PROFIsafe address assignment.
S7-FCT, in conjunction with a GSDML file, allows you to configure selected F-I/Os from Siemens in versions of STEP 7 that do
not natively support the F-I/O and in an engineering system from another manufacturer.
© Siemens AG 2022. All rights reserved
A5E46726754-AC, V1.1, 02/2022
1