Adjustment Of The Tracking Force; Adjustment Of The Azimuth - clearaudio electronic Clarify Bedienungsanleitung

User manual / Bedienungsanleitung

5.3 Adjustment of the tracking force

Turn the counter weight at the end of the tonearm to increase or lower the tracking force.
Pic. 13: Adjustment of the tracking force
Please follow the instructions of the respective cartridge manufacturer.
We recommend using the Clearaudio „Weight Watcher touch" digital cartridge scale (Art. No.
AC163, also available at www.analogshop.de) for the correct setting.

5.4 Adjustment of the azimuth

The azimuth is the angle of the cartridge stylus to the record surface. Viewed from the front, the
cartridge needle has to be vertical to the record.
Please note: The azimuth is already set at the factory.
Pic. 14: Azimuth adjustment
Carefully tighten the small hex screw again without changing the previously selected position.
We recommend the "Mini Level Gauge" from Clearaudio (Art.No.: AK001; also available from www.
analogshop.de) to check the adjustment.
Made in Germany
Caution: Please hold the tonearm tube while rotating
the counterweight to avoid any damages.
red arrow (to the end of the tonearm)
= lower tracking force ->
turn the knob clockwise
green arrow (to the beginning of the tonearm)
= more tracking force ->
turn the knob anti-clockwise
Lower the cartridge onto the record surface and check
the position of the needle if you still want to optimize the
azimuth.
Please proceed as following to change the azimuth:
Loosen the screw (hex wrench #2) on the bottom side of
the tonearm tube near the headshell.
Now you can adjust the azimuth by turning the headshell
in the tonearm tube.
Page / Seite 13