WMF KUCHENminis 6130245383 Gebrauchsanweisung Seite 7

⋅
you suspect that there is a defect after the appliance has fallen or suffered a similar incident.
In cases such as these, send the appliance to be repaired.
▪ Do not immerse the drive unit in water.
▪ We accept no liability for any damages caused in cases of misuse, incorrect operation or improper
repairs. Claims under warranty are likewise excluded in such cases.
Use
The WMF KITCHENminis table blender is a space-saving and energy-efficient kitchen appliance.
You can use the appliance to prepare smoothies, shakes, soups, etc. Thanks to the appliance's compact
design and powerful motor, you can also process only small quantities. Easy and intuitive operation
and the high-quality workmanship / materials guarantee convenient preparation.
* Compared to WMF Lineo table blender.
Confirmed by technikzuhause.de. Resource savings refer to material usage and transportation volume.
Energy savings refer to the maximum power consumption at maximum filling capacity.
Start-up
▪ Clean the glass jug (3), lid (2) and closing cap (1) before starting up the appliance for the first time.
Ensure that you do not injure yourself on the sharp blade.
▪ Place the appliance on an even surface and position the glass jug (3) on the drive unit (8).
▪ Add the ingredients to the jug (3) and close it with the lid (2) and the closing cap (1).
Additional ingredients may be added by removing the closing cap (1), even while the motor is
running.
Note: Ensure that you do not exceed the maximum filling quantity of 0.8 l. If you are using hot,
very liquid or slightly foaming food (e.g. milk), we advise using 0.5 l as the maximum filling
quantity.
Note: Never operate the appliance empty.
▪ Start the appliance by turning the selector switch (8) to the right. Start at a low speed and increase
it if necessary.
To use the Pulse function, hold the selector switch (8) to the left on the Pulse level. The motor will
operate at maximum speed for as long as you keep the selector switch (8) on the Pulse level.
▪ As soon as the desired result has been achieved, switch the selector switch (8) to the Off position
. Only then should you remove the jug (3).
Attention! Risk of injury! Always wait for the blade to come to a standstill before remov-
ing the lid (2). Do not reach into the appliance before the mains plug has been unplugged.
Completely empty the glass jug (3) following use. Do not leave any liquid in the jug (3).
▪ In case of overheating of the motor during use, the device will stop automatically for self-protec-
tion. Unplug the power cord from the wall outlet and allow the unit some time to cool down. Then,
plug the power plug back in and start the mixing process again.
12
Examples Speed
Instant drinks, cocktails Low (min.)
Soft fruits (e.g. bananas, apricots) Low (min.)
Milkshakes / smoothies with soft fruits Low (min.)
Soups, sauces Medium
Milkshakes / smoothies with harder fruits Medium
Vegetables Medium
Frappés Medium
Milkshakes / smoothies with frozen High (max.)
fruits, green smoothies
Crushing ice cubes
Fill the glass jug (3) no more than halfway with ice cubes and close it with the lid (2) and cap (1).
Move the selector switch (8) to the Pulse level for a few seconds and then back to the Off position
As soon as the ice cubes have fallen back to the bottom of the glass jug (3), you can switch to the
Pulse level again for a few seconds. Repeat the process until the crushed ice has the desired consist-
ency.
Glass jug
Lid with closing cap
The closing cap (1) in the lid (2) can be removed and used as a measure (10 / 20 / 30 ml) by turning it
anti-clockwise.
The lid (2) reliably and tightly seals the glass jug. The lid (2) has a tab which you can use to make it
easier to remove the lid.
You can add more ingredients through the opening, even during operation.
Disassembling the glass jug
The glass jug (3) can be disassembled, especially for cleaning.
Remove the lid (2) and the closing cap (1). Place the glass jug (3) on the table
with the opening face-down and turn the locking screw (6) on the blade unit
(5) clockwise (see the figure). You can now remove the blade unit (5) and the
sealing ring (4).
To assemble the glass jug, the sealing ring (4) is first of all attached to the
blade unit (5). When doing so, ensure that the sealing ring (4) is correctly
positioned on the blade unit (5). Then insert the blade unit (5) into the glass
jug. (3) and firmly turn the locking screw (6) anti-clockwise.
Maximum
Maximum filling quantity
time
40–60 s 500 ml
40–60 s 250 g
1–2 mins. 250 g of fruit + 150 ml of
milk / juice
1.5–2 mins. 500 ml
1.5–2 mins. 250 g of fruit + 150 ml of
milk / juice
1.5–2 mins. 250 g
1.5–2 mins. 250 ml of coffee + 4 ice
cubes
40–60 s 250 g of fruit + 150 ml of
milk / juice
.
13