Cleaning And Maintenance - Concept OV2012 Bedienungsanleitung

USE
1. Plug the dehumidifier into an electrical outlet.
2. Press the ON/OFF button.
3. Use the mode button to select the desired mode (automatic, continuous operation, laundry drying, fan).
Automatic mode:
Set the desired humidity to 30-80% and adjust the fan speed level.
Continuous operation:
Automatically sets humidity and fan speed to 1st power level.
Laundry drying:
Automatically sets humidity and fan speed to 2nd power level.
Fan:
Only the fan is on, no dehumidification.
Timer:
Timer can be set for these modes (0-24 h).
HOW TO STOP OPERATION
Press the on/off button to interrupt the power supply, this will stop the operation and all LEDs will go out. (Warning: Do not disconnect the appliance from
the mains during operation. Be sure to turn off the appliance first and then unplug the power cord. Otherwise it may damage the electrical components and
shorten the life of the appliance.)

CLEANING AND MAINTENANCE

• To prevent electric shock, never connect or disconnect the plug with wet hands.
•
Prior to cleaning or maintenance, first switch the appliance off and disconnect it from the mains.
• To prevent device malfunctions or excessive noises, keep the unit in the upright position.
• Wipe the body of the appliance with a soft, dry cloth.
•
Use a soft, damp (well wrung) cloth to remove larger dirt deposits. Never use a damp cloth to clean the control panel.
• To avoid any deformation or cracking, do not use gasoline, thinner or other liquid detergents.
•
Chemicals can cause colour changes of the surface of the appliance.
If you are not going to use the appliance for a prolonged period of time:
1. Unplug the unit.
2. Empty the water tank, wipe it with a cloth and return it to the unit.
3. Clean the air filter.
4. Store the unit in upright position in a dark place, do not place it on the side and avoid direct sunlight.
How to empty the water tank
1. Turn off the device.
2. Remove the tank from the unit.
3. Grasp the tank by the handle and move it gently.
4. Tilt the tank and carefully drain water out.
5. Put the tank back in the unit.
Note: Water is collected in the tank during the operation. A full water tank indicator will start flashing indicating that the water tank is full and the dehumidifier
automatically stops operating.
Cleaning the filters (Fig. 1-2)
1. Remove the grille with filters on the air inlet.
2. Remove the coarse filter and then the carbon filter from the cover.
3. Rinse the coarse filter under water, dry thoroughly and carefully vacuum the carbon filter.
4. Reinstall the filters in the cover and insert the cover into the appliance.
Warning:
1. The operating temperature of the dehumidifier is 5-32 °C. Use the appliance within this temperature range. If you use the device outside the specified
temperature range, the safety fuses will stop the operation. This is normal.
2. If the room temperature is below 5 °C, the humidity is relatively low and the dehumidifier cannot be used.
3. The built-in compressor produces heat and it slightly increases the room temperature during operation. This is normal.
4. The dehumidifier stops operating as soon as the water tank is full.
5. The dehumidifier cannot start or stop the operation itself, in this case check the following steps:
1. Make sure that there is no problem with the plug and the socket.
2. If it seems there is no problem, wait 10 minutes.
3. If the appliance still does not work, contact your dealer.
6. Keep a minimum distance of 15 cm between the openings of the appliance and near objects.
OV2012 | OV2120 | OV2216 | OV2220
EN
31