Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Sensor installation:
We recommend installing the floor sensor in a corrugated tube (Ø 16mm - see
picture).
in order to be able to replace it easily in the event of a fault.
For information on how to install the floor sensor on your heater, please read the
installation and operating instructions for your heating mat.
Sensor error:
E0: internal sensor short-circuited or disconnected.
E1: external sensor short-circuited or disconnected.
If error E0/E1 is displayed, you should check the thermostat and eliminate the error.
Disposal note
Do not dispose of this appliance in household waste! Electronic devices must be
disposed of in accordance with the Waste Electrical and Electronic Equipment
Directive via the local collection points for waste electronic equipment.
Note on conformity
The CE mark is an over-the-counter mark that is addressed exclusively to the
authorities and does not imply any assurance of properties.
Documentation © 2022 Mi-Heat Heizsysteme GmbH
All rights reserved. No part of this manual may be reproduced or duplicated in any form without the written consent of the publisher. It is possible that this
manual contains typographical defects or printing errors. We accept no liability for errors of a technical or printing nature and their consequences.
Mi-Heat Heizsysteme GmbH
Ol Streek 39a
26607 Aurich
Germany
Internet:
mi-heat.com
E-Mail:
info@infrarot-fussboden.de
8
Werbung
