Connecting The Battery - Ryobi ZTR480ex Kurzanleitung

WARNING
Strictly adhere to all torque wrench
tightening specifi cations. Failure to do so
could cause serious personal injury.
WARNING
Do not attempt to modify the product or
create accessories not recommended for
use with the product. Any such alteration or
modifi cation is a misuse and could result in
a hazardous condition leading to possible
serious personal injury.
WARNING
To prevent accidental starting that could
cause serious personal injury, always
remove the start key from the product when
assembling the parts.

CONNECTING THE BATTERY

See fig. 2
When shipped from the factory, the product's
batteries are disconnected.
To connect:
1. Press the tabs on the wiring cover, and lift
the cover to remove.
2. Connect the two ends of the battery
quick-connect plug together.
3. Reinstall the wiring cover, and ensure that
it is securely seated.
Wiring Cover
Tab
Battery quick-connect plug
4 | English
ASSEMBLY
INSTALLING THE SEAT
See fig. 3.
1. Remove the bolts and flange nuts from
the seat mounting brackets.
2. Place the seat assembly over the
mounting brackets, aligning the holes as
shown.
3. Reinstall and securely tighten the bolts
and flange nuts.
NOTE: To tighten the bolts, lift up the
seat. Make sure that the bolt heads are
on the outside and the flange nuts are on
the inside of the mounting bracket. Make
sure that the shoulder of the bolt is fully
seated in the mounting bracket.
4. Connect the seat safety interlock cable to
the plug on the mower.
Shoulder
bolt
Safety interlock
Fig 2
Seat assembly
Plug
cable
Flange nuts
Mounting
bracket
Fig 3