Herunterladen Inhalt Inhalt Diese Seite drucken

Final Checks - Ryobi ZTR480ex Kurzanleitung

Vorschau ausblenden Andere Handbücher für ZTR480ex:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 20
CHECKING THE TYRE AIR PRESSURE
Check the air pressure in all tyres before
use. Improper air pressure affects handling,
steering response, traction, tyre life, level
cutting, and operator comfort. Ensure that
tyres are infl ated to the recommended
pressure.
Front : 1.3 bar
Rear: 1.25 bar
NOTE: Measure or adjust air pressure only
when the tyres are cold.
WARNING
Check the tyre pressure carefully while
infl ating. Too much air in the tyre could
cause the tyre to burst, causing serious
personal injury.
CHECKING THE SIDE DISCHARGE CHUTE
SAFETY INTERLOCK SYTEM
See fig. 9.
Before using the product, check that the side
discharge chute is properly closed. The side
discharge chute has an interlock system that
stops the blades if the side discharge chute is
opened while the blades are running.
Stop using the product, and have it serviced
by an authorised service centre if the blades
do not stop when the side discharge chute is
lifted by an obstacle during use.
8
| English

FINAL CHECKS

TESTING THE OPERATOR PRESENCE
SAFETY INTERLOCK SYSTEM
See fig. 10.
The safety interlock system stops the blades
if the operator leaves the mower while the
blades are running. Test the system before
each use to ensure that it is working correctly.
1.
Stop the product on a level surface, and
engage the parking brake.
2.
Set the drive levers in the neutral position.
3.
Insert the start key, and turn the key to the
ON position.
4.
Pull up the blade engage knob to activate
the blades.
5.
Briefly stand up but do not get off the
mower.
The blades should stop within 5 seconds. If
the blades do not stop, contact an authorised
service centre.
Do not operate the product until the safety
interlock system has been repaired.
3
Fig 9
1
2
4
Fig 10

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis