Levenhuk Wezzer Teo TH50 Bedienungsanleitung Seite 6

Levenhuk Wezzer Teo TH50 Thermohygrometer
EN
The kit includes: base station, sensor, USB cable, user manual, and warranty.
Getting started
Base station
•
Connect the power cable to the device and connect the DC adapter to the AC power supply; or
•
Open the battery compartment cover (28) and insert 3 AAA batteries according to the correct polarity. Close the cover.
•
Once the batteries are installed, the base station will search for the outdoor units for the first 5 minutes. After that, the base
station can be manually set to receive. To do this, press the CH button, and then press this button again to choose between
channels 1, 2, or 3.
Sensor
•
Open the battery compartment cover (2). Insert 2 AAA batteries according to the correct polarity.
•
Set the desired channel with the switch (4). Close the cover.
NOTE! This weather station can be operated with up to 3 remote sensors. Each remote sensor that is to be connected must be
operated on a different channel. If only one remote sensor is connected, it should be operated on channel 1.
•
To re-establish the sensor connection manually, press RESET using a pin.
Sensor connection
•
Place the base station and the remote sensor within the effective transmission range. Ensure that the channels are assigned after
you set up the power supply for the base station and all the sensors.
•
If the reception is successful, the display will show the temperature and humidity of the respective outdoor sensor. If the values
are not received from a channel, "—" appears on the display. Check the batteries and try it again. Check if there is any source of
interference.
•
When changing batteries, replace the batteries first in the base unit, and then in all the sensors, to re-establish the connection. If
an adapter supplies power to any of the devices, briefly disconnect the power to that device when replacing the batteries. If you
change the batteries only in one of the devices (for example, in the sensor), the signal may not be received correctly.
•
The effective range may differ depending on the unit's position. Due to interference (various remote control devices, etc.), the
maximum distance between the base unit and the sensor may be significantly reduced. In such cases, we suggest moving the
base unit and sensor a little. Sometimes it is enough to move one of these units a few inches!
NOTE! Although the sensor is weather resistant, never place it in direct sunlight or in the rain or snow.
Time setting
Press the SET button and hold it for 3 seconds. The digits that are to be set are flashing. Press UP or DOWN to change the value, and
then press SET to continue.
The setting order: 12/24h > Hours > Minutes > Year > Date/Month or Month/Date format > Month > Date > Weekday (7 languages).
Finally, press the SET button to save the settings and exit.
Alarm setting
Press the SET button, and then press it again and hold it for 3 seconds. The digits that are to be set are flashing. Press UP or DOWN
to change the value, and then press the SET button to continue.
The setting order: Hours > Minutes.
When the alarm rings, press SNZ/LIGHT to activate the snooze function. The alarm will sound again in 5 minutes.
Alert function
Press the ALERT button to turn on or turn off the temperature alert. Then, press and hold the ALERT button for 3 seconds. The digits
that are to be set are flashing. Press UP or DOWN to set the desired value limit.
The setting order: outdoor temperature upper limit → outdoor temperature lower limit → outdoor humidity upper limit → outdoor
humidity lower limit → indoor temperature upper limit → indoor temperature lower limit → indoor humidity upper limit → indoor
humidity lower limit.
Finally, press the ALERT button to save the settings and exit.
6