Possible Problems And Solutions - Fysic FX-6000 Gebrauchsanweisung

15 POSSIBLE PROBLEMS AND SOLUTIONS

15.1 POSSIBLE PROBLEMS AND SOLUTIONS
• No dialling tone.
The outside line is being used by another unit. Wait until that call
−
has ended and try again.
Check the connection between the base and you telephone
−
socket (when in doubt, connect a different phone to your
telephone socket).
• The power supply is interrupted.
Check whether the adaptor below at the rear of the base is
−
plugged in and that the power adaptor is connected with a wall
socket.
15.2 PROBLEMS WITH INCOMING CALLS:
• No notification of incoming calls:
The bell is disabled; enable it.
−
Check the connection between the phone and your telephone
−
socket (when in doubt, connect a different phone to your tele-
phone socket)
• You are continuously busy:
Check whether you have a 2nd telephone with the receiver next to
−
it.
Check whether another handset registered on your telephone is
−
keeping the line busy.
Connect another phone to your phone connection, and use this to
−
check whether the malfunction originates from your connection or
your carrier.
• Handset switches itself off when it starts ringing:
The batteries cannot supply power for the ringtone. Clean the bat-
−
tery contacts or replace the batteries.
44