Power On/Off - AUDIOropa PRO LOOP NX7 Bedienungsanleitung

4.6.7 Fault status relay
The error status of the loop driver can be read out via the potential-free relay output.
4.6.8 Terminal assignment:
All connectors are electronically balanced..
XLR
Pin 1 : Ground/Shield
Pin 2 : not inverted / hot (+)
Pin 3 : inverted / cold (-)
6,35 mm Stereo jack
Tip not inverted / hot (+)
Ring inverted / cold (-)
Shaft Ground/Shield
4.6.9 Power on / off
The unit is powered up using the switch on the rear panel of the loop driver. If the device
is powered, the Power LED on the front panel lights up.
To switch the unit off, press the power switch again.
Please note that the device enters a stand-by mode when switched off.
Disconnect the mains plug from the socket in order to switch off the device completely.
3pin-XLR
6.35 mm plug
English 23