Operation - auna Peggy Sue Bedienungsanleitung

EN
16

OPERATION

1. Connect the appliance to the USB port of a computer using the USB
cable supplied or plug the power supply unit supplied into the wall
socket.
2. Place a record on the turntable. If necessary, do not forget to remove
the puck from its anchorage and apply it to the plate.
3. Select the appropriate speed using the speed switch.
4. Turn the volume control (on/off switch at the same time). The power
LED indicates the status of the appliance.
5. Lift the tone arm slightly and guide it over the first grooves of the
record. The record player will now automatically start spinning the
record.
6. Now carefully lower the tone arm so that the needle gently touches
down on the record.
7. Enjoy your music selection!
8. When a record comes to its end, the turntable stops automatically,
provided the Auto Stop switch (5) is set to ON. If it is set to OFF, the
turntable continues to turn until the tone arm is put back.
9. Protect the needle with the supplied protective cap when the record
player is not in use.
Connecting and digitising LPs
With the record player, you can enjoy music on the move - but for home use,
there are also outputs for the home stereo system.
Simply connect the rear RCA outputs with a suitable cable to the AUX input
of your existing system.
If you want to digitise your records, use the rear USB output and connect
the record player to the USB port of your computer. With the supplied
AUDACITY music software, you can set the USB input of the computer as the
signal source for the recording (is preset during installation). Please refer
to the software manufacturer's information for further instructions on the
respective procedure.