HELIX DSP PRO MK3 Bedienungsanleitung Seite 29

HELIX Extension Card slot (HEC slot)
It is possible to extend the functionality of the
HELIX DSP PRO MK3 by inserting an optional
HELIX Extension Card (HEC) – for example a
High Definition Bluetooth
ule, a High Resolution Audio USB soundcard etc.
To install a HELIX Extension Card it is necessary
to remove the side panel of the DSP PRO MK3
and replace it by the new side panel that comes
with the HEC module.
Attention: Install the HEC module only in the
designated device and its specific slot. Using
the HEC module in other devices or slots can
result in damage of the HEC module, the signal
processor, the head unit / car radio or other
connected devices!
Read in the following the steps how to install a
HEC module:
1. First disconnect all cables from the device.
2. Dismantle the side panel where the USB input
is located by removing the five Phillips screws.
3. Pull out the bottom plate sideways.
4. Prepare the module for installing it into the de-
vice. Any further mounting information will be
found in the instruction manual of the respec-
tive HEC module.
5. Insert the HEC module into the specific slot
of the device which is marked in the following
picture.
6. Make sure that the HEC module is installed
properly and all pins are fully inserted into the
socket.
Audio Streaming mod-
®
7. Reinsert the bottom plate and fix the new side
panel which is delivered with the HEC module
with the five Phillips screws.
8. Bolt the HEC module to the side panel. Pre-
cise mounting information will be found in
the instruction manual of the respective HEC
module.
9. Reconnect all cables to the device.
10. Turn on the signal processor. The HEC mod-
ule is automatically detected by the device
and the Status LED of the HEC module lights
up green.
11. Now you are able to configure the HEC mod-
ule in the DSP PC-Tool software.
en
29