HELIX DSP PRO MK3 Bedienungsanleitung Seite 27

Configuration of a subwoofer remote control
In order to configure a subwoofer remote control, specific settings have to be made in the DSP PC-Tool.
First, the appropriate remote control must be activated in the "Extended Features" tab in the DCM menu
en
of the DSP PC-Tool software and configured, depending on the model.
If the VCP is not activated, the subwoofer remote control of the DSP PRO MK3 is permanently as-
signed to the output channels I and J. In this case it does not matter which output is named "Subwoofer"
in the IO routing matrix.
In the "Outputs" menu you can also see to which outputs the SubRC (subwoofer remote control) is tied:
When VCP is activated, the subwoofer remote control is tied to the output channels that are supplied
with one of the two virtual subwoofer signals ("Subwoofer 1" or "Subwoofer 2") in the "Virtual to Output
Routing" matrix. This can be any combination of output channels.
In the following example these are the pre-amplifier outputs I and J:
Note: Please note that an input signal must be assigned to the two virtual subwoofer signals
" Subwoofer 1" and / or "Subwoofer 2" in the other routing matrices.
Afterwards, the subwoofer control is also displayed in the "Outputs" menu next to the name of the chan-
nel [SubRC]:
27