Polar CK640 Bedienungsanleitung Seite 21

Viewing other information about the active
cycle:
Check that the keypad is not locked.
1. Touch the DOWN key to view the remaining
time of the maximum duration of the blast
chilling/freezing cycle (or the elapsed time
from the end of the maximum duration of the
blast chilling/freezing cycle if it has failed).
2. Touch the DOWN key again to view the type of
active cycle.
Label LED
Temperature controlled blast
PoS
chilling and conservation
Temperature controlled blast
nEG
freezing and conservation
3. Touch the DOWN key again to see the cabinet
temperature.
4. Touch the SET key (or take no action for 15 s)
to exit the procedure.
After a power failure during a cycle, the cycle is
automatically reactivated from the phase it was
in at the moment the power failed. If power fails
during blast chilling/freezing, it is reactivated from
the beginning.
Activating the last cycle carried out
Check that the keypad is not locked and that
defrosting is not active.
1. Touch the START/STOP key for 2 s.
2. Touch the START/STOP key within 60 s. The
display will show the duration of the time
controlled blast chilling/freezing or the product
temperature at the end of the temperature
controlled blast chilling/freezing.
3. Touch the SET key.
4. Touch the UP or DOWN key within 15 s to set
the value.
5. Touch the SET key (or take no action for 15 s).
6. Touch the START/STOP key again within 15 s.
The settings are temporary. When a new cycle is
activated (and after a power failure), the device
will restore the r1/r2 and r3/r4 values.
CK640_ML_A5_v5_20221025.indb 21 CK640_ML_A5_v5_20221025.indb 21
Interrupting an operating cycle:
Check that the keypad is not locked.
•
Settings
Check that the appliance is in Standby mode.
Setting first level configuration
parameters
Description
1. Touch the SET key for 4 s: the display will
2. Touch the UP or DOWN key to select a
3. Touch the SET key.
4. Touch the UP or DOWN key within 15 s to set
5. Touch the SET key (or take no action for 15 s).
6. Touch the SET key for 4 s (or take no action
Setting second level configuration
parameters
1. Touch the SET key for 4 s: the display will
2. Touch the SET key.
3. Touch the UP or DOWN key within 15 s to set
4. Touch the SET key (or take no action for 15 s).
5. Touch the UP or DOWN key to select a
6. Touch the SET key.
7. Touch the UP or DOWN key within 15 s to set
8. Touch the SET key (or take no action for 15 s).
9. Touch the SET key for 4 s (or take no action
Touch the START/STOP key for 2 s.
show the label "PA"
parameter.
the value.
for 60 s) to exit the procedure.
show the label "PA".
the PAS value (default "-19").
The display will show the label "CA1".
parameter.
the value.
for 60 s) to exit the procedure.
EN
21
2022/10/25 17:35 2022/10/25 17:35