Activating An Operating Cycle - Polar CK640 Bedienungsanleitung

EN
Signals
LED On
Compressor
switched on
Defrost active
Evaporator fans on
Temperature
controlled cycle
active
Conservation active
Alarm active
Temperature
°C/°F
displayed
Time displayed
min
Time controlled
cycle is selected

Activating an operating cycle

Check that the keypad is not locked and that defrosting is not active.
1. Touch the SET key to select a cycle.
Label LED
PoS
nEG
PoS
nEG
2. Touch the START/STOP key within 15 s.
18
CK640_ML_A5_v5_20221025.indb 18 CK640_ML_A5_v5_20221025.indb 18
Off
Compressor Compressor protection in progress
switched off
- Dripping active
Evaporator fans Evaporator fan delay in progress
off
- •
•
•
•
- Setpoint during conservation being set
- -
- -
- Residual time maximum duration of temperature
controlled blast chilling/freezing displayed
- Time controlled cycle active
Time controlled blast chilling and conservation (if E0 = 0 or 1)
Time controlled blast freezing and conservation (if E0 = 1 or 2)
Temperature controlled blast chilling and conservation (if E0 = 0 or 1)
Temperature controlled blast freezing and conservation (if E0 = 1 or 2)
Flashing
Temperature controlled cycle selected.
Test to check needle probe is correctly inserted in
progress; when time controlled cycle LED is on,
test has failed and time controlled cycle is active.
When alarm LED is on, blast chilling/freezing has
failed and temperature process is active.
When alarm LED flashes, blast chilling/freezing
has failed and conservation is active.
Description
2022/10/25 17:35 2022/10/25 17:35