Troubleshooting - Scheppach PM1600 Original Bedienungsanleitung

13. Troubleshooting

Problem
Motor does not start.
Unusual vibrations
The device starts up, but
blocks when the load is
low and may switch off
automatically.
24 | GB
Possible cause
No power supply (power failure)
Mains cable defective.
Motor or switch faulty.
Beater defective.
Chuck defective.
Non-intended material to be mixed.
Extension cable too long, or cross-
section too small.
Socket too far away from main
connection, and cross-section of
connection lead too small.
www.scheppach.com
Remedy
Check fuses
Exchange defect cable, respectively
check extension cable, (by electrician)
Never use defect lead
To correct the problem, refer to the manu-
facturer or other approved service centre.
Replace the beater.
To correct the problem, refer to the manu-
facturer or other approved service centre.
Incorrect processing. Follow the process-
ing instructions from the supplier.
Extension cable at least 1,5 mm
mum 25 m long.
Cross- section of at least 2,5 mm
longer cables.
, maxi-
2
in
2