Replacing The Lamps; Warranty & Service; Error Messages; Cleaning And Maintenance - Sunshower ONE S Benutzerhandbuch

THE MOVING SENSOR WIL ACTIVATE THE DISPLAY
• Press the ON/OFF button for about 1 second.
• The time bar wil show the 10 min, 1 min for each LED stripe. During the session it wil count down.
• Pressing the OFF button during a session will end the session prematurely.
• After switching off, the Sunshower will cool for ± 5 minutes before it can be used again.
• Time bar wil flash white and each LED stripe is for 1 minute.
Start / Stop

CLEANING AND MAINTENANCE

• Users may only clean the outside of the Sunshower.
• The Sunshower may only be cleaned manually.
• Never use a high-pressure washer to clean the Sunshower.
• Do not clean the Sunshower while the device is switched on.
Use mild cleaning agents to clean the Sunshower: glass cleaner or "all-purpose cleaner" can cor-
rode and dull the glass. A special Sunshower maintenance package is available. It consists of a
mild cleaner and a coating that protects the Sunshower against limescale. For more information,
email: info@sunshower.nl.
EN | User Manual ONE | P6082 - REV1 | 4

REPLACING THE LAMPS

The IR lamps (750 - 1000 W) have a long lifespan of 5,000 hours with minimal performance
degradation. They should only be replaced if they no longer work at all.
WARRANTY & SERVICE
The Sunshower carries a 2-year warranty. This guarantee is subject to correct installation in
combination with your proof of purchase. Sunshower is only responsible for product and design
defects. Sunshower cannot be held responsible for the consequences of careless use of this prod-
uct or for the consequences of violating local regulations. The right to claim under warranty will
lapse in the event of damage caused by failure to observe these instructions for use. We are not
liable for material damage or personal injury caused by improper use or failure to observe the
safety instructions. In such cases, the warranty will be void.
Time indication

ERROR MESSAGES

1) Sunshower not responding
• The button must be pressed for approximately 1 second. If it is not pressed long enough, the
Sunshower will not respond.
• The Sunshower is still cooling down. Time bar (each LED is for 1 minute)
• Check in the meter cupboard whether the fuse switch has tripped and whether the main
switch is ON.
2) Sunshower stops during a session
• The electronics can be sensitive to dips in the mains voltage (longer than 10 ms), which can
cause the Sunshower to stop during a session. Let the device cool down for 10 minutes and
start a new session.
• The Sunshower has overheated and switched off automatically. Check that the ventilation
openings are not blocked.
If you are unable to resolve the malfunction, please complete the service form on our website
www.sunshower.nl/service. You can also contact Sunshower on +31 (0)20 46 21 460 or send an
email to service@sunshower.nl