Tools Required - Sentiotec Country Montageanleitung

Instructions for installation

1.6. Tools required

● Hammer with a wooden head and a mallet
● Cordless screwdriver with bits for cross-head screws and Torx
● Roller tape measure
● Drill bits with a diameter of 4 mm, 5 mm, 6 mm, 20 - 30 mm
(for sauna heater power cable)
● Spirit level
● 17 mm open-ended wrench
● Utility knife
● Ladder
● Saw
This symbol indicates tips and useful information
Pre-drill
Cut to real measurement
Check the right angle:
80 cm
Handle glass with care: Special care must be taken with the edges of
the glass – hardened glass can shatter into small pieces in the event of
impact. Insert protective cushioning (e.g: cardboard box) under the edge
of the glass.
p. 6/6