Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Permanent Operation
Switching-on:
Switching-off:
Attention!
Use the lock button only when using a stand. In the case of any
stopping of the machine or current interruption the lock-on button has
to be released immediately by pressing the on/off switch, to prevent
an unintentional restarting of the machine (danger of injuries)
The stirrer is equipped with an electronic switch.
With this switch the speed can be regulated according to the pressure on
the button. The use is only recommended for the starting and running out of
the machine to avoid material flying around. A permanent operation with
reduced speed will cause an overload because the motor then gets less
cooling air and therefor the machine will be overheated much faster.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel.
After every repair the machine has to be inspected by an
electric specialist.
Due to its design, the machine needs a minimum of care and maintenance.
However, the following points always have to be observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the
machine.
In case of failure, a repair has to be carried out by an authorised
service workshop.
press the on/off switch and, keeping it pressed, engage the
lock-on button
press the on/off switch and let it go off again
15
Werbung
