Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Safety Instructions
Safe work with the machine is only possible, if you read
these operating instructions completely and strictly
follow the instructions contained herein.
In addition, the general safety instructions in the
enclosed brochure have to be observed. Take part in a
practical introduction before the first use.
If the connection cable is getting damaged or cut during
the work, don't touch it, but instantly pull the plug out of
the socket. Never use the machine with damaged
connection cable.
The machine must neither be wet, nor be used in humid
ambient conditions.
Do not use the tool for mixing materials either in danger of explosion or
easily inflammable.
Do not carry the tool at its cable.
Always check the tool, cable and plug before use. Have damages only
repaired by specialists. Only insert the plug into the socket when the
tool switch is OFF.
Modifications of the tool are prohibited.
When the machine runs outside, always use a protection switch
(30 mA max.) against fault current.
The machine should only run under supervision of somebody.
Pull the plug and switch the machine off if it is not under supervision, e.
g. in case of setting up and stripping down the machine, in case of
voltage drop or when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. This way, you
avoid that it starts suddenly and not under supervision.
Always lead the cable to the back, away from the machine.
Do not use the machine if a part of the housing is damaged or in case
of damages on the switch, the connection cable or plug.
Power tools have to be inspected by a specialist in regular intervals.
Keep the handles dry, clean and free of oil and grease.
Do not touch rotating parts.
Be careful with long hair. Only work with close-fitting clothes.
Persons under 16 years of age are not allowed to use the machine.
When working with this machine wear ear protectors, goggles and
protective gloves.
13
Werbung
