Klarstein FORLI Bedienungsanleitung Seite 22

EN
22
Sealing without vacuum
1. Fill the bag with the desired contents. Make sure that the distance between
the bag contents and the place where the bag is to be sealed is at least 7 cm.
2. Press the two lock/unlock buttons (13) and open the cover.
3. Place the edge of the bag over the heating wire at the closure line (14). The
bag must not protrude beyond both edges of the closure line (14).
4. Smooth the bag so that it does not wrinkle where it touches the heating wire.
5. Close and lock the lid until you hear a click from the lock/unlock buttons (13).
6. Press the seal button (2), the seal indicator (7) lights up and the machine
creates a seam on the bag.
7. When the sealing indicator (7) goes out after about 6 seconds, the sealing
process is complete.
8. Wait a few seconds. Open the lid and carefully lift out the bag.
Vacuum sealing
1. Fill the bag with the desired contents. Make sure there is at least 7 cm of space
between the bag contents and the place where the bag is sealed.
2. Press the lock/unlock buttons (13) and open the lid.
3. Place the edge of the bag over the heating wire at the sealing line (14) and
insert the opening of the bag into the vacuuming area inside the air sealing
strip (15). The bag must not protrude beyond the end stoppers (16) and the
edge of the air sealing strip (15).
4. Smooth the bag so that it does not wrinkle where it touches the heating wire.
5. Close and lock the lid until you hear a click from the lock/unlock buttons (13).
6. Press the vacuuming and sealing button "Vac Seal/Cancel" (5), whereupon the
corresponding automatic indicator (12) and the vacuuming indicator (6) light
up and the appliance sucks the air out of the bag until a vacuum is reached.
The vacuum indicator (6) goes out. The seal indicator (7) lights up and the
machine creates a seal seam on the bag. When the sealing indicator (7) and
the automatic indicator (12) go out after about 6 seconds, the vacuum sealing
process is complete.
7. Wait a few seconds. Open the lid and carefully lift out the bag.
Vacuuming without sealing
1. Press the lock/unlock buttons (13) and open the lid.
2. Connect the vacuum hose (20) to the air intake opening (17) and connect the
other side of the vacuum hose to the vent opening of the vacuum container or
wine stop accessory.
3. Press the "Vacuum" button (1) and the vacuum indicator (6) lights up and the
appliance sucks the air out of the canister or wine bottle until a vacuum is
reached. The vacuum indicator (6) goes out as soon as the vacuuming process
is completed.
Note: The vacuuming process can be cancelled at any time by pressing the
"Cancel" button (5).