TFA 35.1122 Bedienungsanleitung Seite 9

TFA_No. 35.1122_Anl. 07.09.2012
MODUS PLUS – Wireless weather station
Caution!
Risk of injury:
• Keep this instrument and the batteries out of reach of children.
• Batteries must not be thrown into the fire, short-circuited, taken apart or
recharged. Risk of explosion!
• Batteries contain harmful acids. Low batteries should be changed as soon
as possible to prevent damage caused by a leaking battery. Never use a
combination of old and new batteries together, or batteries of different
types. Wear chemical-resistant protective gloves and glasses when han-
dling leaked batteries.
Important information on product safety!
• Do not place the unit near extreme temperatures, vibration or shock.
• Protect from moisture.
• The instrument is protected against splash water, but is not watertight.
Choose a shady and dry position for the transmitter.
5. Elements
Weather station (Basic station)
A: LCD display (Fig. 1):
A 1: Weather tendency indicator
A 2: Weather forecast icon
A 3: Moon phase display
A 4: Battery symbol for outdoor transmitter
A 5: Reception symbol for the outdoor transmitter
A 6: Outdoor transmitter channel symbol
A 7: Circle symbol for automatically alternating channel
A 8: Outdoor temperature and humidity
A 9: Symbol for maximum value
A 10: Symbol for the indoor values
A 11: Indoor temperature and humidity
A 12: Symbol for minimum value
A 13: Battery symbol for weather station
A 14: Radio-controlled time symbol
A 15: Time with seconds
A 16: Alarm time symbols
B: Buttons on the weather station (Fig. 1):
B 1: MODE/ENTER button
B 2: MAX/MIN button
▼/UNIT button
B 3:
16
14:18 Uhr Seite 9
MODUS PLUS – Wireless weather station
▲/CH button
B 4:
B 5: ALARM button
B 6: SNOOZE button
C: Housing (Fig. 2):
C 1: Wall mount hole
C 2: Battery compartment
C 3: Stand (fold out)
D: Outdoor transmitter (Fig. 3):
Housing front:
D 1: LED
Housing backside:
D 2: Wall mount hole
D 3: Battery compartment
Buttons in the battery compartment:
D 4: RESET button
D 5: CH button
6. Getting started
Insert batteries:
• Place both instruments on a desk with a distance of approximately 1.5
meter. Check that no other electronic devices are close.
• Insert at first three new batteries 1,5 V AA in the battery compartment of
the basic station and then two new batteries 1,5 V AA in the battery com-
partment of the outdoor transmitter. Make sure the polarities are correct.
Reception of outdoor temperature and humidity
• The basic unit automatically starts scanning the signals to register the
outdoor transmitter after batteries are inserted. The basic unit will scan
for 2 minutes the outdoor values. The reception symbol flashes.
• The LED indicator of the transmitter is flashing. The outdoor transmitter
is set to channel 1 by default.
• If the reception of outdoor values fails, "- -" appears on the display.
Check the batteries and try it again. Check if there is any source of inter-
ference.
• Manual initialization can be helpful. Press and hold ▲/CH button for
3 seconds. The reception symbol flashes. The weather station will only
search for an outdoor transmitter on the actual selected channel.
Radio-controlled time reception
• The clock will now scan the DCF frequency signal and the DCF symbol
flashes on the LCD. When the time code is received successfully after 3-8
minutes, the radio-controlled time is displayed and the DCF symbol
remains permanently on the display. During the DCF time reception period,
no outdoor values will be transmitted.
17