Cleaning; Storage; Maintenance - Scheppach 5910001901 Originalbetriebsanleitung

This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables of the same designation.
The printing of the type designation on the connection
cable is mandatory.
For single-phase AC motors, we recommend a fuse
rating of C 16A or K 16A for machines with a high start-
ing current (from 3000 watts)!

13. Cleaning

NOTE!
Risk of damage!
Highly-concentrated water treatment agents can dam-
age the pool filter system.
- Do not put any water treatment agents, in particu-
lar in tablet form, into the pump strainer or the pool
filter system.
• Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub the
product clean with a clean cloth or blow it off with
compressed air at low pressure.
• We recommend that you clean the product directly
after every use.
• Clean the product at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the product. Make sure that no water can
penetrate the interior of the product. Water entering
a power tool will increase the risk of electric shock.
28 | GB

14. Storage

The pool filter system and the hoses are at best com-
pletely disassembled and stored in a frost-free room at
the end of the swimming pool season.
If the pool filter system is outdoors overwinter, the fil-
ter tank, filter pump and the lines must be completely
emptied.
The filter medium must also be removed from the fil-
ter tank, – for example with a wet vacuum cleaner –.
The manometer on the multi-way valve must be disas-
sembled and stored somewhere frost-free. Damaged
caused due to frost is not covered by the warranty!
Store the product and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The op-
timum storage temperature lies between 5 and 30 ˚C.
Store the product in its original packaging. Cover the
product to protect it from dust or moisture. Store the
operating manual with the product.

15. Maintenance

Attention: Unplug the pool filter system from the mains
before performing maintenance.
General maintenance
The swimming pool must be maintained and serviced
in accordance with the relevant provisions of the man-
ufacturer.
It must be ensured that the height of the water in the
pool always reaches at least to the centre of the skim-
mer.
Maintaining the filter tank (5)
The fill height and composition of the quartz sand
must be checked regularly. The sand must flow loosely
through your hands. All the quartz sand must be re-
placed if lump formation occurs.
If the filter balls are heavily contaminated, the entire
content must be replaced.
Maintenance of the pre-filter
The pre-filter installed in the pump must be cleaned
from time to time depending on the degree of contam-
ination.
www.scheppach.com