Replacing The Lamp; Troubleshooting; Environmental Concerns - Electrolux LFD619Y Benutzerinformation

46 www.electrolux.com

5.4 Replacing the lamp

This appliance is supplied with a LED
lamp. This part can be replaced by a

6. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
6.1 What to do if...
Problem
You cannot activate the
appliance.
You cannot activate the
appliance.
You cannot open the slider
and the panel blinks red
and white.
The lamp does not oper‐
ate.
The appliance does not
absorb enough vapours.
The filter alarm indicator
is on.

7. ENVIRONMENTAL CONCERNS

Recycle materials with the symbol
Put the packaging in relevant containers
to recycle it. Help protect the
environment and human health by
recycling waste of electrical and
electronic appliances. Do not dispose of
technician only. In case of any
malfunction refer to "Service" in the
"Safety Instructions" chapter.
Possible cause
The appliance is not con‐
nected to a power supply
or it is connected incorrect‐
ly.
The fuse is blown.
The glass inside the appli‐
ance is opened.
The lamp is defective.
The motor speed is not ad‐
equate to the appearing
vapours.
The filter alarm is on. The
grease filter must be
cleaned or the charcoal fil‐
ter must be replaced or
cleaned.
appliances marked with the symbol
.
with the household waste. Return the
product to your local recycling facility or
contact your municipal office.
Remedy
Check if the appliance is
correctly connected to the
electrical supply.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Close the glass. Refer to
"Closing the glass" in the
"Before first use" chapter.
Replace the lamp. Refer to
the "Care and Cleaning"
chapter.
Change the speed of the
motor.
Refer to the filter notifica‐
tion in "Daily use" chapter.