Replacing The Lamp; Troubleshooting - Electrolux DAL5536SW Benutzerinformation

Repeat the first two steps for all filters.
3. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
4. To mount the filters back follow the first
two steps in reverse order.
Repeat the steps for all filters if applicable.
6.3 Replacing the charcoal filter -
optional
WARNING!
Depending on type, filter can be or
cannot be regenerated. Refer to the
leaflet provided with the filter.
To replace the filter:
1. Remove the grease filters from the
appliance.

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate the appliance.
You cannot activate the appliance.
You cannot activate the appliance.
The lamp does not operate.
The appliance does not absorb
enough vapours.
Refer to "Cleaning the grease filter" in this
chapter.
2. Pull the tabs towards the bottom part of
3. Slightly tilt the front of the filter
4. To install a new filter, perform the same
In any case, it is necessary to replace the
filters at least every four months.

6.4 Replacing the lamp

This appliance is supplied with a LED lamp.
This part can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
Possible cause
The appliance is not connected to a
power supply or it is connected in‐
correctly.
The fuse is blown.
Cabinet doors are not aligned with
the cabinet frame.
The lamp is defective.
The motor speed is not adequate to
the appearing vapours.
55
the filter.
downwards, then pull.
steps in reverse order.
Remedy
Check if the appliance is correctly
connected to the electrical supply.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Align the cabinet doors.
Replace the lamp. Refer to the
"Care and Cleaning" chapter.
Change the speed of the motor.